Fulltext available Open Access
License: 
Title: Dynamische Spannungsversorgung für Schrittmotoren für die Integration imTreiber-IC
Other Titles: Dynamic supply control for stepper motors for integration in the driver IC
Language: German
Authors: Mattich, Patrick-Alexander
Issue Date: 11-Mar-2019
Abstract: 
Die vorliegende Masterarbeit beschäftigt sich mit der Entwicklung einer dynamischen Erhöhung der Versorgungsspannung eines Schrittmotors, basierend auf einem Aufwärtswandler, zur Aufrechterhaltung des Drehmoments über einen größeren Drehzahlbereich. Aufgrund der gegen-elektromotorischen Kraft sinkt das Drehmoment von Schrittmotoren bei Verwendung einer niedrigen Versorgungsspannung mit steigender Drehzahl früher als bei Verwendung einer hohen Versorgungsspannung. Diese Arbeit sollte beantworten, inwiefern die Implementierung in einen Schrittmotortreiber-IC eine lohnende Entwicklung wäre. Dazu wurde ein Testaufbau basierend auf einem FPGA entwickelt und auf einem Motorteststand mit herkömmlichen Schrittmotortreibern verglichen.
Der neue Ansatz verbessert das Drehmomentverhalten im Vergleich zu einer herkömmlichen Schrittmotorsteuerung signifikant. Dies wird durch eine dynamisch angepasste Versorgungsspannung erreicht.

The maximum torque stepper motors can produce decreases with the increasing speed of the motor because of the back electromotive force. This means that a low supply voltage leads to a decrease of the torque at a lower speed than a higher supply voltage would achieve. The goal of this thesis is to develop a motion system including a dynamic boost converter for increasing the supply voltage of a stepper motor to maintain high torque over a wider speed range. The results should indicate whether the integration of a dynamic voltage supply in a stepper motor driver IC would be a beneficial development.
To this end a test setup based on a FPGA was developed and compared to a regular stepper motor driver using a motor torque tester. The results show that using the dynamic voltage supply results in significantly better torque at higher speeds than the regular stepper driver, while using the same low external voltage supply.
URI: http://hdl.handle.net/20.500.12738/8628
Institute: Department Informations- und Elektrotechnik 
Type: Thesis
Thesis type: Master Thesis
Advisor: Riemschneider, Karl-Ragmar 
Referee: Schütt, Reiner Johannes 
Appears in Collections:Theses

Files in This Item:
File Description SizeFormat
MA_P_Mattich.pdf9.52 MBAdobe PDFView/Open
Show full item record

Page view(s)

238
checked on Mar 28, 2024

Download(s)

1,668
checked on Mar 28, 2024

Google ScholarTM

Check

HAW Katalog

Check

Note about this record


Items in REPOSIT are protected by copyright, with all rights reserved, unless otherwise indicated.